Storefront material shall be as detailed on the shop
drawings and manufactured by Sun Valley Products, Inc., 4626 Sperry Street, Los Angeles, California and the
glazing contractor shall furnish all necessary material,
labor, and equipment for the complete installation of
the following: storefront sash, division and corner bars,
sill and jamb trim, bulkheads, aluminum frame sections,
and access doors.
Work Not Included:
Structural steel, wood framing, and painting will be done
under their respective section of the specifications.
Storefront sections shall be extruded of 6063-T5
aluminum alloy. Formed sections where indicated shall
be aluminum alloy of proper gauge as shown on the
All exposed portions of extruded aluminum storefront
moldings shall be standard finished such as: anodized,
clear, bronze, or black (please specifiy required finish).
Brake molds and formed sections shall be anodized to
closely approximate the finish of extruded sections.
All items under this section shall be set in their correct
locations as shown in the details; shall be set level,
plumb, square and at their proper elevations, and in
alignment with all work. All joints between metal and
masonry shall be tightly caulked to prevent leakage.
All metal shall be secured in place with fasteners
according to the shop drawings. At all points where
moldings are joined, they should be accurately cut and
neatly fitted to result in a tightly closed joint. After
erection the General Contractor shall adequately protect
all exposed portions of the storefront metal work from
damage by grinding and polishing machines, plaster,
lime, acid, cement, paint or other harmful materials.
The General Contractor shall be responsible for removal
of protective materials and cleaning of the aluminum.
All aluminum shall be thoroughly cleaned with plain
water or a petroleum product such as; white gasoline,
kerosene, or distillate. No abrasive or caustic agents
shall be used.